1.75”
3.41" OAL +/-.03"
Width: .624"
Fits over belts up to 1.75" including thicker riggers belts.
1.5”
3.41" OAL +/-.03"
Width: .624"
Fits over belts up to 1.5".
Features two inline slots to fit virtually any logical hole spacing used by holster makers while providing subtle ride height adjustment for the user.
Inside dimensional tolerances: +/-.03"
Just enough clearance to fit low profile Chicago Screw hardware in the top of the upper slot underneath the grab lip.
Standard DMG/Cu finish: Color - DCC dark matte grey. Non reflective and resists corrosion very well.
***Low Profile Hardware Included***
Care and maintenance: Our new finish does not need much attention. If any light scratches or wear marks develop, we recommend a quick buff with WD40, but anything from vegetable oil to mineral oil to CLP to motor oil will work well. Just put a couple drops on your clip and rub it in vigorously using firm pressure with a lint free cloth. This will help keep it looking it's best cosmetically.
IF YOU NEED TO DRILL ANY ADDITIONAL HOLES IN YOUR KYDEX SHEATH DUE TO LACK OF EYELETS WE SUGGEST YOU USE A 7/32” BIT, USE THE CLIP TO MARK YOUR DRILLING LOCATION